Chesapeake Nautical getting new overhead ready Video - Watch some preparation

An overhead is a afterthought until it becomes degraded

An overhead is one of those details that is easy to ignore until it demands attention. Sometimes they start to collapse, they get dinged up, holes from hardware that's been removed, or adding insulation to safe power used by climate control systems.

How to make a new overhead

  1. Call Chesapeake Nautical
  2. Envision and discuss any improvements over the original design including electrical, ventilation, and access
  3. Begin prepping the work area
  4. Envision how the new overhead will be fitted
  5. Remove hardware either for disposal or re-installation
  6. Remove the old overhead taking measurements as needed for preparing the new one
  7. Clean surfaces - they are always dirty
  8. Design and prepare new overhead
  9. Prep-clean any old hardware for re-use
  10. Prep - install attachment points
  11. Install new electrical and other improvements
  12. Install new overhead
  13. Install fixtures such as lighting
  14. ReInstall old hardware
Installing a new overhead is a combination of design, carpentry, and various other skills depending on the application. It helps to have experience in order to produce a high quality professionally finished product. When you are ready to replace your overhead reach out to schedule your appointment!

Chesapeake Nautical

412 Fourth St.

Annapolis MD 21403

Please call for an appointment

 410-507-9084

[email protected]